Cleaning Instructions And Care Of Your Rapport™ Classic V.t.d - Owen Mumford Rapport Classic Mode D'emploi

Cleaning Instructions and Care of your
Rapport™ Classic V.T.D.
1
The Constriction Rings
After each use, the constriction ring should be washed with mild
soap in warm water, rinsed well and dried thoroughly. Return the
ring to its bag.
Make sure you only use water soluble lubricating jelly with
the constriction rings. Your rings should last for longer if cared
for properly.
2
The Penile Tube and Transfer Sleeve
After each use, the penile tube and transfer sleeve should be
washed thoroughly with a mild soap in warm water. Rinse and dry
well before replacing them into the carrying bag.
3
The Vacuum Pump
Very little maintenance is needed for the vacuum pump, but we
recommend that you occasionally wipe the vacuum pump with a
damp cloth to remove any dirt or lubrication.
the vacuum pump in water or immerse the vacuum pump
under running water, as this may cause handle to stick and
it will not be possible to create a vacuum.
Non return
valve
It will be necessary from time to time to lubricate the O-ring on the
pump head, particularly if you are finding it difficult to attach or
remove the pump head to and from the penile tube.
After cleaning the pump head apply a little petroleum jelly to the
O-ring (the coloured band) making sure you smear the lubricant
all the way around the O-ring. This will ensure a total seal
between the pump head and the penile tube and maintain
the vacuum inside the penile tube.
12
Do not submerge
Please take care when wiping the
underside of your vacuum pump
as the non return valve (three-pronged
rubber valve) can be pushed into the
piston chamber with only a slight
force. If this valve is not in
position, no vacuum will be
achieved.
NOTE: This lubrication of the O-ring
with petroleum jelly is the ONLY use
of petroleum jelly.
Do not allow petroleum jelly to come
in contact with the constriction rings
as it could damage them.
Aquagel ® Lubricating Jelly
Ingredients – Sodium polyacrylate (carbomer), Glycerol, Hiquest
(di-sodium salt of 1-hydroxy ethane-1, 1 diphosphonic acid; sequestrant),
Sodium Nipasept (parabens mix – preservative), Purified water.
Made by ECOLAB.
ECOLAB, Lotherton Way, Garforth, Leeds LS25 2JY, England www.ecolab.co.uk
Aquagel is not a product or trademark owned by Owen Mumford. For more information please
®
contact the relevant manufacturer.
13