Gamma Piu KERATIN GLORY Notice D'utilisation Et Garantie page 9

SWITCHING ON AND USE
Connect the power cord [D] to the mains socket in accordance with the safety
warnings described previously.
The red LED will light up indicating that the plate is connected to the power supply.
Press the [B] key for about 1 second. The blue temperature LED will start flashing.
Select the desired temperature using the [+] and [-] keys [E]. The LED [C] corresponding
to the selected temperature starts blinking.
When the LED [C] stops flashing and turns fixed, it means the plate has reached the
selected temperature.
Proceed with using it according to the type of hair. Refer to the „Straightening tips"
when you wish to straighten your hair.
The straightener reaches high temperatures in a few seconds. Do
not touch the heating elements and do not bring the straightener
too close to your face, ears, neck and skin. RISK OF BURNS.
SWITCH-OFF
Press the [B] key for about 1 second. The red LED will remain on to indicate that the
plate is still connected to the power supply.
Do not pull the power cord or appliance to disconnect the power cord [D] from the
mains socket.
Put the appliance in a safe place and wait as long as necessary for the straightener
to cool completely.
Take care not to wind the power cord around the straightener when storing it.
Standby mode
For greater safety, the straightener will automatically switch-off after 60 minutes of
inactivity, while remaining connected to the mains.
STRAIGHTENING TIPS
This professional hair straightener becomes very hot. We
recommend that utmost attention be paid to the condition of the
hair that is to be treated, especially in the case of bleached and
deconstructed hair. We recommend a maximum of 3 seconds of
application and to always test a hidden lock in advance.
• Wash your hair as usual, dry and brush it to untangle any knots.
• After drying, do not use hairspray, mousse or gel.
• Take a thin lock of hair between your fingers as wide as the heating plate and
place it between the plates.
• Close the hair straightener and hold the lock taut with one hand while sliding
the straightener with the other hand from the roots to the ends to straighten the
hair or open and close the plate, moving it from time to time for the frise version.
• Start styling from the nape of the neck and then move on to the sides and lastly
to the front.
• Continue until the hairstyle is complete.
Steam may be produced while straightening; this is normal due to the excess
moisture in the hair which evaporates.
• Switch the hair straightener off after each use.
MAINTENANCE
In case of malfunction or damage to the appliance or a part of it,
the appliance must be analysed by the manufacturer or the relevant
technical assistance or in any case by a person with similar skills in
order to prevent any risk. The user must not disassemble the device
him/herself.
After each use clean the appliance.
GENERAL CLEANING
• Always disconnect the power cord from the mains socket and make sure the
straightener is completely cool before cleaning.
• Avoid all risk of electric shock by not cleaning the appliance with water and
do not immerse it in water.
• Do not use abrasive solutions or concentrated detergents.
• Clean the exterior with a soft cloth or slightly damp cloth.
• Clean the heating plates with a slightly damp cloth and a mild detergent.
• After use, make sure that all parts are completely dry.
9