ShelterLogic ShelterCoat 11'W x 10'H Peak Mode D'emploi page 6

Your model may have more middle ribs than shown in the illustration on page 3. You will receive one extra rib for
every extra 4 ft. of building length that you purchase. The basic frame assembly will remain the same. The cover
will be the correct size for the length of the building you purchased.
1. PLOTTING THE FRAME:
Before building your shelter, you should choose a flat area on
your property and plot your shelter.
A. Stake out the area for the shelter in the desired spot. The width of
the area should be at least equal to the width of the shelter and the
length should be equal to the length of the shelter Fig. 1.
B. Measure diagonally from corner to corner (A & B). These
measurements should be the same. If they are not equal the stakes
need to be adjusted until the width, length and inside measurements
are correct.
2. ASSEMBLE END RIBS
Assemble end ribs as shown in Fig. 2. Securely
fasten all of the joints with the hardware indicated.
3. ASSEMBLE MIDDLE RIBS
Assemble middle ribs as shown in Fig. 3. Securely
fasten all of the joints with the hardware indicated.
NOTE: FRAME EXTENSION KIT
Fig.2
10132
10223
10127
10128
Fig.3
10132
10223
10126
10113
Page 6
Fig.1
A
BUILDING
LENGTH
10121
800464
800464
Use #10114
/
1
" x 2" L
4
Bolts
10131
800464
Use #10114
/
1
" x 2" L
4
Bolts
05_GP-AA-XXXXXXA-011XXX10_C0
B
11ft. 6in.
WIDTH
10132
10223
10127
10128
800464
10132
10223
10126
10113