Default Setting; Attaching The Lid; Cleaning - Gewa Andromeda REC4 Manuel

Default setting

Andromeda comes preset with Monostable functioning and GewaLink-channels 16-19 on relay 1-4.
Resetting to default setting
To restore Andromeda to the default setting, press and hold the programming button P for 5
seconds until the indicator lamp flashes, and then press the programming button P again within 2
seconds when the indicator lamp remains lit.
NOTE: Any pairing will be deleted.
Resetting a single relay
To restore a selected relay to the default setting, press and hold the programming button P for 5
seconds until the indicator lamp flashes. Then, press the programming button for the relay to be
reset within 2 seconds when the indicator lamp remains lit.

Attaching the lid

On model IRZ-REC REC4 and IRZ-REC4 WM it is possible to attach the lid with the included
screws.

Cleaning

Dip a cloth into water with a little detergent in it and wring it out well. This can then be used to clean
the outer casing of the receiver.
19