Spa Cabinet Care; Spa Surface Care And Cleaning - MAAX Spas Performance 400 Série Guide De L'utilisateur

NOTE: If you elect not to drain your spa
and the temperature is going to be below
freezing for extended periods of time, it is
best to operate the spa heater at the
maximum high temperature to 104°F
(40°C), especially if there is a power outage
threat. This will help keep the spa water
from
freezing if you have a power failure.
If you do not intend to use your spa during
the winter months and there is danger of
freezing, use the following steps to winterize
your spa:
1. Turn off all electrical power to the spa.
2. Drain spa and hoses of all water using the
directions for Draining Your Spa (pg. 27).
Open all unions, and remove drain plugs
from bottom of pumps. If you cannot
draw off all of the water (especially from
hoses), add Recreational Vehicle anti-
freeze to the remaining water through
the bottom of the skimmer and jets. If
antifreeze is used, it must be an inhibitor
NOTE: Prior to refilling the spa, drain all
antifreeze from spa and hoses using
the instructions for Draining Your Spa
(pg. 27). Carefully monitor chemicals
until all antifreeze residue has
dissipated.
3. The filter should be drained, and the
cartridge removed and cleaned.
4. Check to see that there is no water in the
heater element chamber.
5. Clean your spa as directed in the
following two sections on this page.
6. Cover your spa with a water-shedding,
impenetrable cover.
7. For further information on blowing out
the plumbing lines and winterizing
procedures, contact your local dealer.
MAAX SPAS PERFORMANCE SERIES

Spa Cabinet Care

The 300 and 400 series cabinets are made of
Duramaax™, a high quality alternative to
wood that is virtually maintenance free,
requiring no staining, sealing, or waxing.
Never use abrasive cleaners.
To clean the spa cabinet, rinse dirt and dust
regularly with clear water. To remove stub-
born dirt, grime, and mild discoloration, wash
with a mild detergent and warm water.

Spa Surface Care and Cleaning

Your spa shell surface is made of acrylic. A
minimum amount of care and cleaning will
keep your spa looking new for years.
Use a spa cleaner for residue and lime
buildup at the water level of the spa surface.
It may be necessary to lower the water level
2-3 inches (5-7 cm) before cleaning to avoid
polluting the spa. Cleaner can be applied
to the acrylic surface with a soft cloth and
wiped clean. Use a non-abrasive household
cleaner to clean your spa shell or use a mild
dishwashing detergent. Rinse well and dry
with a clean cloth.
NOTE: Do not allow the acrylic surface to
come in to contact with products such as
acetone (nail polish remover), nail polish,
dry cleaning solution, lacquer thinners,
gasoline, pine oil, etc.
Remove dust and dry dirt with a soft, damp
cloth. Clean grease, oil, paint and ink stains
with isopropyl (rubbing) alcohol. Avoid using
razor blades or other sharp instruments that
might scratch the surface.
29