Jets And Air Controls; Jets; Cleaning Or Replacing Jets - MAAX Spas Performance 400 Série Guide De L'utilisateur

JETS AND AIR CONTROLS

Jets

All spa jets are individually engineered to
provide a unique hydro-massage. Depending
on the model, your spa will have a combina-
tion of the following jets:
Cyclone Therapeutic
(XL Cyclone, LS Cyclone, & Cyclone):
Positioned to focus on large muscle groups,
these jets deliver a concentrated, high
volume stream of water for a deep massage.
Each jet is fully adjustable, allowing users to
set the water flow to the most comfortable
setting. The nozzle can be rotated to target
sore muscle areas.
Cyclone Turbo Swirl Jets
(XL Cyclone, LS Cyclone, & Cyclone):
Positioned to focus on muscle tension zones,
these jets deliver a spinning V-shaped water
stream for a gentle, pulsating massage. Each
jet is fully adjustable, allowing users to set
the water flow to the most comfortable
setting.
Whirlpool:
Positioned to create overall water circulation,
this mult-purpose, high volume jet provides
whirlpool action throughout the entire spa.
Cluster Jets:
Positioned in the footwell or shoulder areas
of the spa, these jets deliver a penetrating
massage to dissolve tension.
Ozone Jet:
This jet may be the entry point for ozone pro-
duced during the automatic filtration cycles,
and, as such, is not adjustable.
MAAX SPAS PERFORMANCE SERIES
Note: Ozone production is suspended when
other functions are activated on the control
panel by the spa user.
All full sized jets are adjustable from a fully
open to closed position. It is very important
that you NEVER SHUT ALL FULL SIZED JETS
OFF AT ONE TIME!

Cleaning or Replacing Jets

Hard water can cause calcium/mineral
buildup that can restrict or bind the jets.
A jet consists of a face plate and a nozzle.
Rotate these parts weekly and remove/clean
monthly to ensure free movement.
NOTE: It is not necessary to drain the spa
to clean or remove the jets.
Rotating the jet face plate and nozzle
• Rotate the jet face left and right
(open and closed).
• Return the face plate to the full
open position.
• Turn the jets on to high speed.
• Twist the nozzle left and right.
• Rotate the nozzle in the socket.
NOTE: If the jet insert disengages from the
spa housing, see steps to reinstall below.
Cleaning the jets
To remove the jet insert, use the palm of
your hand to exert pressure on the face of
the jet. Turn counterclockwise until the jet
'clicks' . Gently pull the jet assembly from the
housing.
11