Control Systems; User's Pads - MAAX Spas Performance 400 Série Guide De L'utilisateur

CONTROL SYSTEMS

The Control System offers you the ultimate in
spa control. The backlit, Liquid Crystal Display
(LCD) displays current water temperature, set
point water temperature, time, and operating
mode settings. Each feature of the system is
actuated through a control panel touch pad.
Touch the appropriate pad to activate the
desired function.
At start up, when power is supplied to the spa,
the controls will operate properly and safely
under the factory settings. The spa will be in
Standard Mode, have a temperature setting of
100°F (38°C), and a filtration cycle duration of
2 hours. To fully utilize the unique capabili-
ties of the control system, it is important to
know how to set the temperature, operate the
pumps, operate the light, adjust the mode
setting, and change the filtration cycles.
NOTE: In event of a power outage or failure,
the Control System should retain all
settings, except time of day. If settings are
lost, re-program per the instructions in this
manual and contact your dealer.

User's Pads

User's Pads are the buttons located on the
topside control panel and are used to program
various spa functions (i.e., turn on spa light, set
temperature, etc.). The following table defines
the pads:
MAAX SPAS PERFORMANCE SERIES
Pad Use
- Increase temperature
- Change time settings
Warm
- Decrease temperature
- Change time settings
Cool
- Turn internal spa light on or off
Lights
- Set or lock/unlock temperatures
- Set or lock/unlock panel settings
- Switch modes
- Set time and filtration cycles
Mode/Prog
- Activate primary filtration pump
Jets 1
- Activated therapy pump
Jets 2
- Change time of day setting, or
- Change set times of spa cycles
- Exit programming
Time
- Optional. Turns blower system on or
off. Same as Turbo.
Blower
17