Safety Recommendations; Important; Control Panel Description - S&P DHUM-10 PLUS Notice D'utilisation

– DHUM PLUS RANGE
USE AND OPERATING
INSTRUCTIONS
Carefully read these instructions
before using the appliance, and keep
them safely for future consultation.
The complete range of S&P DHUM
PLUS dehumidifiers complies with the
IEC 60335-1 and IEC 60335-2-40
norms.
It is recommended that you check
and test the appliance on unpacking,
as any defects are covered by the
S&P guarantee.

SAFETY RECOMMENDATIONS

- Ensure that the voltage and power
of the mains supply coincide with
those marked on the characteristics
plate of the appliance.
This plate is situated on the rear of
the appliance.
- If the appliance is to used in a fixed
installation, it should be installed by
qualified personnel and in accordance
with the national regulations
covering electrical installations.
- If the mains cable is damaged, it
should be substituted by the S&P
after sales service or by suitably
qualified personnel, in order to avoid
any possible danger.
- IMPORTANT: Both the front and
rear of the appliance should have
sufficient free space to allow an
adequate flow of air around the unit.
- The dehumidifier must not be used
near baths, showers or swimming
pools.
- This appliance is designed for
domestic dehumidification. It should
not be put to any other use.
- Any manipulation or alterations that
modify the normal working
characteristics of the appliance
represent a potential danger.
- Do not position the unit near heat
sources or in direct sunlight.
- Before transporting the appliance,
disconnect it from the mains and
remove any condensed water from
the deposit.
- Always disconnect the appliance
from the mains if not being used,
before transport or before cleaning.
- Never insert any object into the
interior of the dehumidifier.
INSTRUCTION FOR USE
- DESCRIPTION OF THE EXTERIOR
OF THE APPARATUS (figure 1)
1- Control panel.
2- Dry air outlet flaps.
3- Carrying handle.
4- Humid air inlet.
5- Water deposit handle.
6- Water deposit.
7- Front panel.
8- Humidity control panel.
9- Continuous drainage water outlet.
10- Cable holder.
11- Rear panel.

- CONTROL PANEL DESCRIPTION

(figure 2)
1- "Unit working" pilot light.
2- "Tank full" pilot light.
3- "Defrost function" pilot light.
Starting the apparatus :
1. First, turn the humidity control
switch to the OFF position.
2. Connect the appliance to the mains
electricity supply.
3. Open the dry air outlet flaps. (figure 3)