Maintenance Recommendations; Technical Support - S&P DHUM-12 EN Mode D'emploi

MAINTENANCE RECOMMENDATIONS

1. Disconnect the device from the power supply before carrying out any maintenance operation.
2. Clean the exterior of the device using a cloth moistened with water. Do not use detergents
or abrasive products.
3. Clean the air fi lter once every two weeks with hot water (40ºC). Do not use detergents or
abrasive products. (Fig. 3)
Possible errors and actuations list:
Models: DHUM-12-16-20 EN
Display indication Description
E1 Humidity sensor fault
E2 Temperature sensor fault
Model: DHUM-30 EN
Display indication Description
E1 Humidity sensor fault
E2 Temperature sensor fault

TECHNICAL SUPPORT

S&P's extensive Offi cial Service Network guarantees appropriate technical support.
Should you notice any anomaly in the operation of the device, please contact any of the service
centres listed to obtain technical support.
Any operation on the device which is not strictly necessary for its installation, carried out by
persons other than from S&P's offi cial service centres, will invalidate the guarantee.
To clarify any query you may have concerning S&P products, contact the After Sales Service
Network if you are based in Spain, or your normal distributor if you are located elsewhere. You
can fi nd their location by visiting our website www.solerpalau.com
REMOVAL FROM SERVICE / RECYCLING
EC regulations and our responsibility to future generations require us to recycle ma-
terials; please do not forget to place all residual packaging materials in the relevant
recycling bins and take all redundant equipment to the nearest Recycling Centre.
The refrigerant gas contained in DHUM-EN models is of the R290 type. This refrigerant gas
is covered by European Regulation 517/2014, which limits the use of some fl uorinated gases
from January 1, 2020.
Actuation
Contact After sales Service Network S&P or
your regular dealer
Actuation
Contact After sales Service Network S&P or
your regular dealer
EN
25