METRICA FLASH GREEN 360 Mode D'emploi page 7

2. Locked beam mode
When the lock switch in
ton, both vertical and horizontal laser beams will light
up and flash every 5 seconds, the indicator light is red.
In this case, it is possible to tilt the spirit level arbi-
trarily.
Press the power button
goes out and the vertical line works by flashing every
5 seconds.
Briefly press the power button
power button "SYMBOL" again briefly, the horizontal
line comes on flashing every 5 seconds. and the ver-
tical line goes off.
Briefly press the power button
tal line and the vertical line will be switched on at the
same time, flashing every 5 seconds.
Press and hold the power button for a long time to swi-
tch off the laser level.
3. Power saving mode
In auto-leveling mode and locked mode, briefly press
position, long press the but-
briefly, the horizontal line
again. Press the
again. the horizon-
the pulse button, the brightness of the light can be
adjusted, the brightness is divided into 4 levels. The
green LED indicator is on.
4. Impulse mode
In self-leveling mode, long press the
mode will turn on, long press again to turn off the pulse
mode in this mode, the power-saving mode is not valid.
The green LED indicator flashes.
The indicator light is 4 green LED lights, the amount
of minus indicator lights show that the power minus.
It means weak power when there is only one LED light
flashes, the device should be charged in time.
MAINTENANCE
- The laser instrument is factory sealed and calibrated
to the specified accuracy.
- It is recommended to perform a precision check be-
fore its first use and periodic checks during future
use, especially for precise layouts.
- Do not store the laser instrument in direct sunlight
key, the pulse