Horizon Global 76624 Instructions D'installation page 4

1. Remove hitch panel– Using flathead screwdriver, remove (2) plastic push
fasteners from the center of the bumper fascia. Remove the hitch panel from
the center of the bumper fascia by removing (2) screws with a Phillips
screwdriver. Return screws and hitch panel to vehicle owner.
3. Remove tape from frame – Using a flathead screwdriver, remove the tape
from the outside of the framerails to uncover the weldnuts in the frame.
©2022 Horizon Global Americas Inc. - Printed in Mexico
2. Trim underbody panel – Use tape to mark the bumper fascia support in line
with the slot for the hitch panel and trim out the center of the bumper fascia
support.
Cut Here
4. Install hitch – Raise the hitch into position and secure with the supplied M12
(#1) hex bolts and conical tooth washers (#2).
5. Tighten all M12 fasteners with torque wrench to 76 Lb.-Ft. (103 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when
.
towing
Sheet 4 of 12 76624NP 8-15-22 Rev. A