Care And Maintenance - Hornbach 65463 Notice De Montage

• For the extension of the substructure frames are laid close. The number of collisions should move to row.
• For narrow decks with less than 80 cm width, at least 3 frames must be used.
• The length of the freely projecting board ends may not exceed 5 cm.
• At the board joint, every board end must rest on a separate piece of frame. In these areas, lay the frames in two rows.
Installing the Boards (Figures 3-5)
• The distance from solid building structures must be at least 25 mm; a spacing of 7 mm is required from board to board at the head
joint.
• Fasten the start clips to the subframework in a row from above and slide in the first row of boards.
• Fasten the boards to all frames with one connecting clip each. Initially, only screw in the screws loosely until the head finds a
place in the groove pocket. Slide in the next board and then tighten the clip screw.
• Fasten the last row of boards to the frame with stainless steel screws from above or hidden at an angle in the groove (Figure 5)

Care and Maintenance

• Place sliders of plastic or felt under all furniture, flower pots or shade stands to protect the surface against scratches and other
damage.
• Water spots occur on new decks in particular due to the evaporation of rainwater. This is a temporary phenomenon and generally
disappears on its own after 1-2 months or with water and some dish soap.
• Mud, dirt and algae or moss can be removed with warm water and Faxe deck cleaner. Stubborn build-up can be loosened with a
plastic brush (our advice: rotary disc sander with deck cleaning brush).
• Oils, greases and discolouring liquids should be removed quickly with dish soap.
• Damage such as scratches or burn marks should be removed carefully as far as possible with steel wool, sanding paper or an
abrasive fabric.
Warranty
Wondertech is produced with great care and with constant quality controls. If individual elements are nevertheless found to be
defective on delivery, please contact your dealer.
The warranty applies exclusively to manufacturing-related defects in the delivered goods. Defective elements will be replaced by
defect-free products.
Warranty claims cannot be accepted for products that were processed and installed despite obvious defects.
The warranty claim is voided by improper use or faulty installation and failure to follow the processing instructions.
The costs for installation, transport and travel, lost time and wages are not covered by the warranty.
All information is based on current technical principles and the best available knowledge. Figures may differ from the
actual appearance. Drawings are not to scale. All rights reserved. Subject to technical changes and errors.