Installation Instructions; Part Numbers - Cequent Performance Products 75774 Instructions D'installation

Looking forward on vehicle showing bolts and lock washers in place. Make
sure brackets are vertical inside of cross member depression and then torque
Vehicle
Forward
Hitch forward
attachment hole.
Insert 5/8" thick
block vertically
between hitch bar
and this hole.
Bend up or
remove this tab
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2013 Cequent Performance Products, Inc. – Printed in Mexico

Installation Instructions

Mercedes GLK350
All Models including 4-Matic & RWD
View of Clamp Brackets in place
to 75ft. lbs. before raising hitch up under vehicle.
87593
View of bumper fascia tab
Bend up or remove before installing hitch.
Sheet 2 of 6

Part Numbers:

75774, 87636
Passenger' side
of vehicle
Offset hole
towards
passenger's side
75774N 03/01/13
Form: F205 Rev A 5-6-05
44690
Rev. A