Quax COCOON 54F01-0400XL Serie Manuel page 36

Step 4.4 : Use the top
5, three push systems H
and six wood screws I.
Disassemble the push
systems (H) Place the
mounting plates with
the lip (see red arrow)
facing backward, on the
drillings at the bottom of
the top (5). Tighten each
mounting plate with two
wood screws (I). Push
the systems back onto
their holder.
Quax nv Karel Picquélaan 84 B-9800 Deinze Belgium T
COCOON 54F01-0400xXL
Step 4.3 : Use the right intermediate side 3R, four wooden do-
wels E, a slider L, nine wood screws A, two push systems H,
four wood screws I and ten shelf supports T
Push two wooden dowels (E) into the drillings at the top and
bottom of the intermediate side (3R). Disassemble the slider
(L). Place the outer slider on the holes on the left side of the
intermediate side. Attach the slider with fi ve wood screws (A).
Note the detail. Disassemble the push systems (H) Place the
mounting plates with the lip
on the drillings above and under the slider. Attach the mounting
plate with two wood screws (I). Push the systems back onto
their holders. Push six shelf holders (T) into the drillings on the
right side of the intermediate side. Push four shelf holders (T)
into the drillings on the left side of the intermediate side.
T 0032 9 380 80 95
(see red
36
arrow) facing backward,
Step 4.5 : Use the bot-
tom 4, four mounting
plates N and twenty four
wood screws O.
Place the mounting
plates (N) on the dril-
lings at the underside of
the bottom (4). Push the
wood screws (O) into
the holes of the moun-
ting plates and tighten
them in the bottom.
www.quax.eu - E E info@quax.eu