Dhcp Server - Topcom Xplorer 870+ Manuel D'installation

Xplorer 870+
10. DHCP SERVER / DNS RELAY
The DHCP Server setup entry comes with the following parameters:
Parameters
Value
DHCP/DNS service DHPC parameteres and DNS server addresses

DHCP server

System allocates
address pool
Assign address
pool range
Max Lease Time
Primary DNS
server IP address
Secondary DNS
server IP address
DNS Relay
Auto discovery
Manual settings
The default configuration for DHCP server is enabled with 32 addresses from
192.168.1.2 to 192.168.1.33 for DHCP clients. While DHCP is enabled, you can
select "System allocates address pool"(The default setting is 32 IP addresses.) or
"Assign address pool range" (To Manually assign IP address range.)
Note: The DNS IP MUST be set to a valid value to enable the DHCP server to deliver the DNS IP
to the host. Consult your ISP for DNS IP address. You may input the secondary DNS IP if there
are two DNS servers in your network.
Description
DHCP Server option
System assigned address pool range.
Beginning and end address of the pool range.
Maximum lease time for an IP address in seconds.
Primary DNS server IP address provided by ISP.
Secondary DNS server IP address provided by ISP.
DNS Relay settings
To find DNS server automatically
IP address for the DNS Rlay
21 21 21 21 21 21 21 21 21 21
Default
Enable
Off
86400
N/A
N/A
On
Off