Ppp Over Atm And Ppp Over Ethernet - Topcom Xplorer 870+ Manuel D'installation

Xplorer 870+
Parameters
VPI
VCI
WAN IP
Subnet Mask
NAPT
Consult your service provider for the related IP information for the WAN connection
including IP and Subnet Mask.
To set the VPI/VCI/WAN IP/WAN Subnet Mask parameters including adding,
modifying and deleting, refer to "Setup VPI/VCI " in Configure RFC 1483 Bridged
Mode.
NAPT should be enabled in this mode!
Note: To save the settings, select "Save Configuration" and then click "Save".

8.3 PPP over ATM and PPP over Ethernet

Select PPPoA Mode button to use PPP over ATM connection mode or PPPoE Mode
button to use PPP over Ethernet connection mode. Your Internet Service Provider
(ISP) will tell you the values of VPI/VCI to use after you sign up the service.
In Annex A of this manual you can find some country settings.
Setup WAN Connection
The Wan connection setup comes with the following parameters:
Parameters
Value
VPI
VCI
Username
Password
Description
Virtual path identifier
Virtual circuit identifier
WAN address for static IP only
Selected PVC's Subnet Mask
Network Address Port Translation
Description
Virtual path identifier
Virtual circuit identifier
Username assigned or verified by your service
provider
Password to allow login with your username
18 18 18 18 18 18 18 18
Default Value
N/A
N/A
N/A
N/A
ON
Default
N/A
N/A
N/A
N/A