Ritter RITOS A1D08A1 Mode D'emploi page 9

All manuals and user guides at all-guides.com
• Guide the screw connection seal over the cable as well, and then insert the cable into the junction
box. Ensure the seal is seated in the cable guide correctly – if the connecting cable is too thin,
the cable guide must be additionally sealed.
• Connect the wires according to Figure 1.
• Tighten the cable guide screw connection, install the cable grip, and tighten the screws.
• Install the junction box cover and tighten the screws.
Setting the Floodlight Direction
Loosen the screws on the sides of the mounting brackets, adjust the floodlight direction, and then
retighten all screws.
Cleaning
• Disconnect and lock out the power supply to the floodlight. Allow the floodlight to cool down
sufficiently!
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not
use cleaners that contain abrasives or solvents.
Maintenance
• If the lens is damaged it must be replaced immediately.
• Clean any dirt from the housing or the lens immediately, since it could cause overheating.
WEEE-reference of disposal
In accordance with European defaults used electrical and electronics devices may no
more be given to the unsorted waste. The symbol of the waste bin on wheels refers to the
necessity of separate collection.
Please help with environmental protection and see to it that this device is given to the for
this purpose designated systems of waste sorting if you do not use it any longer.
GUIDELINE 2012/19/EU of the EUROPEAN PARLIAMENT AND the COUNCIL of July 04th 2012
about electrical and electronics old devices.
Warranty
During manufacturing this Ritter-Leuchten product is passed through several quality testing
stations which are set up with newest technology. Should nevertheless a defect arise,
Ritter-Leuchten offers a warranty to the following extent:
1. The duration of the warranty is 24 months after the date of purchase.
2. The unit is either repaired or replaced by Ritter-Leuchten free of charge or if it can be
shown that it has become unusable during the warranty period due to a manufacturing
or material defect.
3. The liability does not cover transport damages or damaged incurred through defective
installation.
4. If Ritter-Leuchten repudiates the warranty claim and no objection is made within 6
months, the right to repair becomes time-barred.
5. In a warranty case the unit must be sent to the dealer or Ritter-Leuchten together with
the sales slip and a short description of the defect.
6. If there is no proof for a warranty liability being in place, any repair carried out will be invoiced.
GB
7