Led Floodlight; Proper Use; General Safety Instructions; Technical Data - Ritter RITOS A1D08A1 Mode D'emploi

GB
All manuals and user guides at all-guides.com

LED floodlight

Operation and maintenance manual
Dear valued customer,
Thank you for purchasing our floodlight. Before operating the floodlight, please read the following
instructions for use carefully and keep them in a safe place for future reference.

Proper Use

The floodlight is spray-protected, IP65 and for use outdoors.
The floodlight conforms with the appropriate European CE regulations

General Safety Instructions

• Never look directly into the led light source. The light emitted can contain the colour blue.
• Use only with a sufficiently protected 230v~ installation.
• Must not be immersed in water or other liquids.
• Must not be operated with wet hands; never look directly into the light source.
• Must never be covered.
• Must never be operated with an open housing, missing or damaged wiring compartment, or
missing or damaged lens.
• Must never be sprayed or cleaned using a steam pressure cleaner since this can damage the
insulation and seals.
• Must never be repaired by the user. Repairs must only be carried out by the manufacturer or an
authorized service representative.

Technical Data

• Type A1D08A1:
• Type A1D14A1:
• Voltage: 230V~, 50Hz
• Protection class: IP65
• Colour temperature: 6500K
Installing
Installation may only be carried out by trained professionals according to the applicable installation
regulations. Contact a licensed electrician. ATTENTION!! Before installation, the power supply must
be disconnected and locked out.
• Loosen the screws on the side of the housing and remove the mounting brackets.
• Install the mounting brackets to a suitable surface – always follow the installation location requi-
rements listed under "General Safety Information".
• Reattach the floodlight housing to the mounting brackets but do not tighten the screws fully.
• Loosen the screws on the back of the junction box and remove the cover.
• Remove the cable guide screw connection and guide it over the connecting cable – the screw
connection thread must face in the direction of the cable end.
• Loosen the cable grip screws and remove the cable grip.
6
Illuminant: 7W LED
Illuminant: 12W LED
Luminous flux: approx. 600lm
Luminous flux: approx. 1000lm