Memco Panachrome+ Guide D'installation page 9

Speech Language
Key Sounds
Door Block
Enabled
Voice Interval
Door Cycle Time
Voice Limit [X]
Voice Limit [ ]
Alert Interval
Fault Interval
Door Cycle
Enabled
Hub Post
Frequency
Advanced
Top Diode
Bottom Diode
Profile
Display
English
French
German
Italian
Spanish
Japanese
OFF
ON
OFF
ON
Low
Medium
High
OFF
ON
10
100
1000
10mm
43mm
Triggers
Status
Averages
Version
Door Cycle
Defaulted to the same as menu language
Keypad sounds OFF/ON
Turn door block ON/OFF
Turn door block OFF
Turn door block ON
Interval between each door blocked announcement
5 seconds
15 seconds
30 seconds
Time in seconds for a full door cycle from door open to door
closed
Number of announcements when triggered
Number of announcements when untriggered
Time in minutes before door block alert sent to hub. Alert
will be repeated at the same interval (default 5 mins)
Time in minutes before door block fault alert is sent via
email. This will then repeat at the same interval (default 15
mins)
Counts the number of full door cycles from last power ON
When enabled the number of door cycles will be posted to
the hub
Don't post to the hub
Post to the hub when the door counter reaches the hub
post frequency
Number of door cycles at which the door cycles are sent to
the hub
Send every 10 cycles
Send every 100 cycles
Send every 1000 cycles
Sets which diode is the top (first) diode in the beam pattern
(1 to 6). This can be used to deactivate top diodes if they are
triggered by the door mechanism. Note that using this may
not be in compliance with EN81 requirements
Sets which diode is bottom (last) diode in the beam pattern
(12 to 48). Note that using this may not be in compliance with
EN81 requirements
G2510/G3510
G2540/G3540
Displays the last type of trigger and the distance at which
it occurred. If it is a 2D trigger it will display which board or
boards the trigger occurred on
Coded display of configuration and status
Signal levels
Firmware version
Displays number of door cycles since last power up