Menu Navigation - Memco Panachrome+ Guide D'installation

4. Menu Navigation

Panachrome + settings can be changed by using the 4-button keypad and screen.
To enter the settings menu first press ▼.
Press ▼ and ▲ to go to the desired function then use  to select. Some of the functions have multiple choices so use ▼
and ▲ to view. An active function is indicated by a * symbol.
Note: the bottom line on the display is the active function or menu item. The top row displays 'Panachrome
first level is selected then changes when sub-menus are accessed.
For example:
First level Second Level
Visible Diodes ▼
Panachrome
+
Mode
Visible Diodes
There are 3 types of tones when navigating through the menus:
1. Single short high pitched – menu navigation
2. Single low pitch tone – incorrect selection
3. Three short tones – settings change confirmation
Profile Selection:
The Controller must be configured for the correct width. Incorrect choice may result in regular false triggers, particularly
near to closed.
For initial installation, press the down key until menu indicates Quick Config, Select this, then down until the correct
model is chosen. When selected, the Controller will emit a series of beeps. This also sets all configurations to factory
settings.
To change just the profile setting, select Advanced, Profile Width, then 10mm or 43mm.
Key Function
Go back/cancel
▼
Menu and value down
▲
Menu and value up

Menu item select and confirm
' when the
+