Memco Panachrome+ Guide D'installation page 4

Detectors, External Speaker and Hub
The RX and TX can be plugged into either of the two 5-way DIN socket as the controller uses intelligent software to
determine which one has been connected.
Fig 4: Installation
An optional external speaker can be connected to the centre 2-way terminal block.
Panachrome+ can connect to an Avire DCP using CANBus wiring
The Avire hub allows remote configuration of the system, and monitoring of fault events.
Wiring:
Connect the CAN bus to J3 on the controller
If this is the final product on the CAN bus set SW1 to On, otherwise set to Off.