Memco Panachrome+ Guide D'installation page 7

5. Menu Navigation
Language
English
French
German
Italian
Spanish
Japanese
Quick Config
G3510
G2510
G3540
G2540
G3550
Visible Diodes
Mode
Sides
Ext. Inp. Open
Ext. Inp. Close
Green On Time
Red On Time
Language selection
Quick Configurator for Product Versions
(2 = 2D, 3 = 3D) (10 = 10mm, 40 = 43mm)
Green ON when the detectors are triggered and the doors are
Normal open/opening. Flashing red when the doors are closing and
solid red when closed
Enables control of the visible diodes by the open and close
External Inp. door signals. Choose whether this is activated by the rising or
falling edge of an external signal (see Section 6 for details)
Demo Continual demo sequence of green and red diodes
Visible diodes will change from green to red when the
Trigger
detectors are triggered
OFF Turns off visible diodes
Both ON
This controls which detector, either TX or RX have their visible
TX only ON diodes ON or OFF. The default is both TX and RX visible
diodes ON
RX only ON
Rising Edge
Door open signal rising or falling edge signal (see Section 6 for
details)
Falling Edge
Rising Edge
Door closing signal rising or falling edge signal (see Section 6
for details)
Falling Edge
Sets green diodes on time (10 to 1000s)
Sets red diodes on time (2 to 1000s). Note: flashing/solid
combined on time