Publicité
Les langues disponibles
Les langues disponibles
MOUNT PLATE FOR "GLACIER PRO" PLOW FRAME
KIT PN 2879105
INSTALLATION WITHOUT WINCH INSTALLED
1. Fasten the upper part of the mount plate a to frame
using the
(4) M12-1.75 X 30 mm
supports d, and the
(finger tighten at this time).
NOTE : Be sure to use the correct mounting holes.
2.
Fasten the lower part of the mount plate a to frame
using the
(3) M10-1.5 X 35 mm
lock washers i, and the threaded support e.
Tighten all bolts and nuts.
NOTE : Be sure to use the correct mounting holes.
Front of
the ATV
7515232
A-7515232
hex bolts g, the
(2)
nylock nuts h
(4) M12-1.75
FRONT VIEW
hex bolts f, the
(3) M10
LEFT FRONT VIEW
USE THE PUSHFRAME WITH ANGLE OR
LIFTING HYDRAULIC KIT
To allow the installation of an angle or lifting hydraulic
system, a new front grille b is included in this kit. This
grille is composed of an opening for easy installation of
a hydraulic system.
1. Remove the roller guide if it's installed.
2. Remove the existing front grille. Retain the bolts.
FRONT VIEW
3. If your vehicle is equipped with a winch, remove the
central part of the new grille b:
a) Using cutter, cut the two clips on the lower
part of the new grille b.
b) Fold the central part of the new grille b
from front to rear until it is completely
removed.
- 3-
Printed in China
Publicité
