Blaupunkt BPA 3022 M Mode D'emploi page 21

SPECIFICATION
GENARAL
Power Supply Requirements
Chassis Dimensions
Tone Controls
- Bass (at 100 Hz)
- Treble (at 10 kHz)
Maximum Output Power
Current Drain
RADIO
Frequency Coverage
IF
Sensitivity
Stereo Separation
TROUBLE SHOOTING
Symptom
No power
No sound
The operation
keys do not
work.
The radio does
not work. The
radio station
automatic
selection does
not work.
No playback of
the phone music
APP.
: DC 12 Volts, Negative Ground
: 129 (W) x 112 (D) x 65 (H)
: ±10 dB
: ±10 dB
: 4 x 40 watts
: 10 Ampere (max.)
FM
87.5 to 108 MHz
10.7 MHz
4 µV (S/N = 30 dB)
>25 dB
Cause
The car ignition switch is
not on.
The fuse is blown.
Volume is set to minimum.
Wiring is not properly
connected.
The built-in microcomputer
is not operating properly due
to noise.
The antenna cable is not
connected.
The signals are too weak.
Unit is paired with another
mobile phone.
AM
522 to 1620 KHz
450 KHz
36 dBµV (S/N = 20 dB)
/
Solution
If the power supply is connected
to the car accessory circuits, but
the engine is not moving, switch
the ignition key to "ACC".
Replace the fuse.
Adjust volume to a desired level.
Check wiring connection.
Press the reset button.
Insert the antenna cable firmly.
Select a station manually.
1) Turn off the Bluetooth function of
another mobile.
2) Exit APP and turn on APP again.
EN