Tare Function; Cleaning And Care - Orbegozo PC 2026 Manuel D'instructions

PC 2026
Hold function: the measured result is shown for 8 seconds after the weighed part got
removed from the scale surface. After 8 seconds the display will automatically switch to 0. If
user press tare, the scale is at 0 directly.

TARE FUNCTION

- If you want to weigh items in a container, the container should be placed on the weighing surface
before you switch on the scales. You may also delete the weight of the container pressing the
button. The display will show "0".
-Now add the items to weigh. The weight will be shown on the display. Touch
again show "0". Now you may add the next item to weigh. You may repeat the procedure several
times as desired.
ERROR DISPLAY INTRODUCTION
- The scale has a load capacity of max. 20 kg. The display will show "Err" if this maximum load is
exceeded.
- The symbol
INTRODUCTION OF USING AND ISTALLING THE BATTERIES
- Use 1xCR2032 (included)
- To insert or replace the battery, open the battery compartment located underneath the unit. When
inserting the battery, always observe the correct polarity. Please put 2XCR2032 battery into the
battery compartment.
ADVIDE FOR USE AND CARE
Always put the scale on a clean and flat table.
•
To ensure the life of the scale, do not put the scale under wet, hot & cold conditions.
•
The product is a high precision electronic weighing apparatus. Therefore do not drop
•
otherwise the scale can be easily damaged.
If the scale surface is dirty, please clean the scale with soft cloth, do not use any chemical
•
detergent and don't allow water to get inside the scale.
If the result appears improperly, please check about whether the batteries and the touching
•
point contact well. Replace with new batteries if used for a long time already, then try again.

CLEANING AND CARE

The device may be wiped with a soft dry or slightly damp, lint free cloth.
Do not use any abrasive, harsh cleaning solutions or aggressive solvents for cleaning.
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances must not be disposed of in the normal
unsorted municipal waste stream. Old appliances must be collected separately in order to
optimize the recovery and recycling of the materials they contain, and reduce the impact on
human health and the environment. The crossed out "wheeled bin" symbol on the product
reminds you of your obligation, that when you dispose of the appliance, it must be separately
appears if the batteries need replacing.
. The display will
8