Philips Lightolier C4RR Installation

Downlighting
Calculite LED gen 3
remodeler
This luminaire is intended for installation in accordance with the National Electrical Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before installation.
To prevent electrical shock, turn off electricity at fuse box before proceeding. Allow fixture to cool before handling.
Retain these instructions for maintenance reference
Installation for
Calculite Rough-in section
for non-IC remodeler:
• C4RR • C6RR
• C4SR • C6SR
May require minimum center-to-center spacing installation. Must reference light module instruction sheet IS-MS_IC.
Ceiling installation
Serrated
bracket
Support
ring
Fig.A
Step 1
ceiling plate
Cut an opening in the
ceiling to accommodate
ceiling adapter
the remodeler to be
installed (Fig.A). Ensure
decorative nut
that there is nothing in
(reflector mount only)
the ceiling to obstruct
the installation.
decorative plate
(ceiling mount only)
© 2016 Philips Lighting Holding B.V. All rights reserved. Philips reserves the right to make changes in specifications and/or to discontinue any product
at any time without notice or obligation and will not be liable for any consequences resulting from the use of this publication. philips.com/luminaires
IS-C4_R_en 10/16 page 1 of 1
Read and understand these instructions
before installing luminaire (fixture).
Caution (RISK OF FIRE)
This is a non-IC rated frame-in kit. Do not install insulation above or
within 3 inches (76mm) of any part of luminaire. Use only with LED light
modules and reflector trims provided by Philips Lightolier. Use of other
• C7RR
manufacturers trims may void the Underwriters Laboratories listing and
could constitute a fire hazard.
ceiling plate
ceiling adapter
decorative nut
(reflector mount only)
CEILING
decorative plate
Fig.B
(ceiling mount only)
Step 2 Step 3
ceiling plate
Pass the support ring Wire to supply leads. White wire to neutral supply lead, black wire to hot
into the ceiling (Fig.B). supply lead, and bare copper and/or green wire must be connected to
ceiling adapter
Slide the springs onto supply ground. Use wire nuts (local hardware item). Place all electrical
the serrated bracket connections in the j-box and close the j-box door. For luminaires with 0-10V
decorative nut
(Fig.C). Press the springs dimming, or digital dimming, wire purple & gray leads to appropriate control
(reflector mount only)
down against the back wires. Additional brown, yellow and red wires are for emergency battery
of serrated bracket and pack installations and should remain capped off when not in use. Additional
decorative plate
lower them to the ceiling. orange wire is for future expansion and should also remain capped off.
(ceiling mount only)
CEILING
J-Box
mounting
bracket
Spring
(press down)
Fig.C Fig.D
CEILING
CEILING
IS-C4_R
Step 4
Fold j-box into
ceiling using the
j-box mounting
bracket as a guide
(Fig. D). Notches
in bracket align
with typical
ceiling thicknesses.