Alarm List - Ingersoll Rand 1000 Manuel De L'opérateur

AUTO RESTART: Y
SET
Depressing the SET button changes the AUTO RESTART
parameter from "N" to "Y".
AUTO RESTART: Y
ENTER
Depressing ENTER saves the selected set point.
WARNING
Changing the AUTO RESTART feature to "Y" will
permit the dryer to operate automatically once power
is applied and after a brief delay. Proper warning
signs should be affixed to the dryer to alert users
and service personnel that dryer may start without
warning. Failure to do so may result in serious injury.
SELECT
DISPLAY
Depressing the SELECT DISPLAY button displays the
END TECH SET PTS display.
The remaining non-adjustable parameters may be viewed by
depressing the SELECT DISPLAY button as required to arrive at
the desired display.
NOTICE
To exit the TECHNICIAN MODE at any time, depress
the button located above the SET button to return
to the CUSTOMER MODE.

10.2 ALARM LIST

At the end of the list of non-adjustable parameters, the
Microprocessor Control displays a list of the most recent 20
alarm conditions. This list can facilitate troubleshooting the
dryer.
SELECT
DISPLAY
At the end of the list of parameters, depressing the
SELECT DISPLAY button displays the beginning of the ALARM
LIST.
SELECT
DISPLAY
18
10.0 TECHNICIAN MODE
END TECH SET
PTS
BEGIN ALARM
LIST
HPCO ALARM
Nirvana Cycling Refrigerated Dryer Models 1000-1600
Depressing the SELECT DISPLAY button displays the
alarms that the dryer has experienced, with the most recent
alarm displayed first. The actual display will depend on the
most recent alarm detected by the Microprocessor Control.
SELECT
DISPLAY
The list of alarms can be scrolled by depressing the
SELECT DISPLAY button as needed. At the end of the alarm list,
the END ALARM LIST screen is displayed.
SELECT
DISPLAY
Depressing the SELECT DISPLAY list displays the
ALARM LIST screen at the top of the ALARM LIST.
The Alarm List will repeat as many times as the SELECT DISPLAY
button is depressed. To EXIT the ALARM LIST, perform the
following:
Depressing the BLANK button (located above the SET
button) returns the controller to the top of the TECHNICIAN
MODE.
Depressing the BLANK button again returns the
controller to the default display of the CUSTOMER MODE.
ingersollrandproducts.com
END ALARM LIST
BEGIN ALARM
LIST
TECH SET MODE
CHLLR TEMP: 37