Basic Operations; General Cutting Instructions - RIDGID CM1450 Manuel Du Propriétaire

Basic Operations

General Cutting Instructions

WARNING: Always wear safety
glasses when operating the cut-
off machine. To reduce the risk of
burns from contact with hot cut
off workpieces, wear protective
gloves.
WARNING:
a. Always securely fix the mate-
rial to be cut by using the vise.
b. Always disconnect the tool
from power source before mak-
ing any adjustment.
c. Do not use any type of cutting
lubricant with this tool.
Familiarize yourself with the following
functions of the RIDGID cut-off machine
before connecting it to a power source
and using it.
1. When starting this cut-off machine for
the first time or after it has been idle for
awhile, always let the machine run for
one full minute with the wheel com-
pletely recessed into the guard before
making any cuts. If there are any
unknown defects in the wheel that
could cause breakage they usually
would do so within the first minute of
operation. If the wheel wobbles or
vibrates, discard and replace immedi-
ately.
2. When beginning a cut with the tool,
care should be exercised not to bump
or slam the wheel into the work; once it
has entered, continue the cut with an
even smooth stroke. The faster a cut is
made the less heat is created in the
workpiece, preventing discoloring, and
wheel life is prolonged. Cut with a
steady force without overloading the
motor.
3. Use an outboard support when cutting
long, heavy pieces to prevent them
from tipping the machine or falling
down after they are cut.
4. When transporting the machine lock
the power head to the base to prevent
damage.
5. When cut-off wheel comes up to full
speed, push the handle to begin cut-
ting. It is important to cut with steady
and even pressure (Do Not Force) in
order to obtain a uniform cut.
17