Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Maintain Tools With Care. Keep the
machine clean for best and safest
performance. Follow instructions for
To Reduce The Risk Of Injury From Jams, Slips Or Thrown Pieces
• To reduce the risk of burns or other
fire damage, never use the machine
near flammable liquids, vapors or
gases.
• Choose the right 14-inch diameter
cut-off wheel for the material and
the type of cutting you plan to do.
For example, when cutting alumi-
num, use an abrasive cut-off wheel
especially designed to be used on
aluminum.
• Make sure the cut-off wheel is
undamaged and properly aligned.
With the machine unplugged, push
the power-head all the way down.
Hand spin the cut-off wheel and
check for clearance. If the abrasive
wheel hits anything, make the
Plan Ahead To Protect Your Eyes, Hands, Face and Ears
Know Your Machine. Read and
understand the owner's manual and
labels affixed to the tool. Learn its
applications and limitations as well as
the specific potential hazards peculiar
to this tool.
To reduce the risk of injury from acci-
dental contact with moving parts,
don't do layout, assembly, or setup
work on the machine while any parts
are moving.
Reduce The Risk of Accidental
Starting. Make sure switch is "OFF"
before plugging tool into a power out-
let.
Plan your work.
Use The Right Tool. Don't force tool
or attachment to do a job it was not
designed to do. Use a different tool
for any workpiece that can't be held in
a solidly braced, fixed position.
lubricating.
Remove Wrench from tool before
turning it on.
adjustments shown in the "Align-
ment" section.
• Make sure the abrasive wheel and
arbor collars are clean.
• Make sure the collars' recessed
sides are facing the abrasive cut-off
wheel.
• Using the arbor wrench supplied,
make sure the arbor screw is firmly
hand tightened.
• Make sure all clamps are tight and
there is no excessive play in any
parts.
• Keep Work Area Clean. Cluttered
areas and benches invite accidents.
Floor must not be slippery.
CAUTION: When cutting any met-
als, sparks or hot fragments
could cause a fire.
Dress for safety.
Any power tool can throw foreign
objects into the eyes. This can result
in permanent eye damage. Always
wear safety goggles, (not glasses)
complying with ANSI Z87.1 (or in
Canada CSA Z94.3-99) shown on
package. Everyday eyeglasses have
only impact resistant lenses. They are
not safety glasses. Safety goggles
are available at many local retail
stores. Glasses or goggles not in
compliance with ANSI or CSA could
seriously hurt you when they break.
5
Publicité
Table des Matières
