Publicité
Les langues disponibles
Les langues disponibles
TO BEGIN PLAYBACK
Before turning on the power
Make sure that the input terminals and output terminals are securely connected.
Playback
1.
Turn the volume knob of the Pre-Amplifier to its lowest setting.
2.
Set the Pre-Amplifier's power switch to ON.
3.
Set the unit's power switch to ON.
The power indicator will light red for eight seconds. The light will turn yellow once the unit is ready to operate.
Use the Pre-Amplifier's volume knob to adjust the volume.
4.
To turn off the unit after use, first turn the volume knob of the Pre-Amplifier to its lowest setting, then turn off both
the Pre-Amplifier and the unit.
Protection circuit
The unit is provided with a built-in automatic protection circuit to prevent electrical damage to the amplifier and
speakers. When the protection circuit operates, the power indicator will light red, and no sound will be produced from
the speakers. The protection circuit may operate in the following circumstances:
When power is first turned ON
In order to silence potential noise during startup, the muting circuit operates for eight seconds; the indicator lights
red during this time.
In event of malfunction
In the event of a short-circuit between speaker terminals, excessive load, or abnormal heat generation, the protection
circuit will operate and the indicator will light red. In the event the protective circuit is triggered by an anomaly, turn
the power off once, then remove the cause of the anomaly and turn the power back on.
Precaution for instances protective circuit is triggered
The protective circuit is triggered if installation conditions are not appropriate and when the internal temperature of
the speaker becomes abnormally high, or if core wires of speaker cables are protruding out of speaker terminals and
come into contact with case metal portions of speaker base units. In such cases, turn the power off, verify and remedy
any inappropriate installation conditions or check and rectify connection of core wires in speaker cables that are
protruding out of speaker terminals and touching case metal portions of speaker base units, then turn the power back
on. If the protective circuit is still triggered, pull out the power cable and contact your dealer.
TAD-M700 / TAD-M700S
17
Publicité
