TAD M700 Mode D'emploi page 14

BI-AMP Connection
[Example of BI-AMP connection using Speaker system with BI-AMP connection terminal]
TAD-M700S
To balance output terminal
TAD-M700S
AUTO POWER DOWN
ON
OFF
BI-AMP connection is a method of connecting Low / high sound input terminals of speaker using 2 pair amplifier and
speaker cords.
Two TAD-M700S are required in BI-AMP connection.
 Make sure that power supply switch of this apparatus and each component is not Turn ON while connection and
switching over of Switch.
 Connect the speaker corresponding to BI-AMP at the time of connection. Moreover, set the BI-AMP switch to "BI-AMP".
 Connect High and Low of each speaker to respective power amplifier speaker terminal pair (SPEAKER L terminal and
SPEAKER R terminal).
CAUTION
 Input signal is connected to 2 apparatus with input R terminal. Signal from input L terminal is not output to speaker at
the time of BI-AMP settings.
Note
It can be connected to either High or Low as same
signals are output from SPEAKER L and R.
14
R
BI-AMP STEREO
INPUT R INPUT L
STEREO BI-AMP
(BALANCED) (BALANCED)
SPEAKERS
R L
+
−
High
Low
Rear side of bi-wiring
compliant speakers
Pre-Amplifier
L
TAD-M700S
AUTO POWER DOWN
ON
OFF
CAUTION
 To avoid harmful effects on amplifier while BI-AMP of
speakers, make sure to remove High-Low short metal
fittings attached to speaker. For details, refer to Speaker
Operating Manual.
To balance output terminal
BI-AMP STEREO
INPUT R INPUT L
STEREO BI-AMP
(BALANCED) (BALANCED)
SPEAKERS
R L
+
−
High
Low
Rear side of bi-wiring
compliant speakers