Technoline WS1700 Mode D'emploi page 41

Display screen not working
No outdoor sensor
reception
Rainfall display error
Inaccurate weather
forecast
No RCC signal
Wrong temperature

Check the batteries in main unit are inserted and power
adaptor is plugged in correctly

Check the batteries in sensor are inserted correctly

Battery may need to be replaced

Relocate the weather station and the sensor. The
maximum transimission range is 100m without obstriction

Press and hold "OUT" key for RF reception again

Try to reset the units, take the sensor near the weather
station, reinstall the batteries and replug power adaptor,
place the sensor outdoor until reception success

Check the distance of the weather station and the sensor
from the sources of interference (computer monitors or
television sets). It should be at least 1.5 to 2 m during the
reception of the signal.

Remove rain gauge cover to see if any obstruction inside

Make sure the rain gauge is mounted securely

Make sure the outdoor sensor cable connect properly

Currently displayed icon means the forecast for the next
12–24 hours. It may not reflect the current state of the
weather.

Set the correct altitdue

For accurate barometric pressure trends, the weather
station should operate at the same altitude for recordings
(i.e. it should not be moved from the ground to the second
floor of the house). When the unit is moved to a new
location, discard readings for the next 12 hours and
correct the height adjustment if needed

Move the weather station to another location and try to
detect the DCF signal again.

Check the distance of the weather station from the
sources of interference (computer monitors or television
sets). It should be at least 1.5 to 2 m during the reception
of the signal.

When receiving DCF77 signal, do not put the weather
station to the proximity of metal doors, window frames
and other metal structures or objects (washing machines,
dryers, refrigerators etc.).

In reinforced concrete structures (cellars, high-rise
buildings etc.), the DCF signal reception is weaker,
depending on the conditions. In extreme cases, place the
weather station close to a window

Press "MODE" to check if it is in alert mode. In the alert