Publicité
Les langues disponibles
Les langues disponibles
3. Place the sensor near the main unit in order to establish an effective wireless
transmission. Do not place the sensor outside until the transmission has be confirmed.
4. Observe the LCD screen to see outdoor temperature and humidity displayed to
confirm the transmission is completed
NOTES:
First plug in the adaptor or insert the batteries of main unit, then insert the batteries of the
outdoor sensor in 3 minutes after the main unit is powered on, to assure of the sensor
data received well.
In case of the outdoor sensor data received failure, please press "OUT" key for more than
3 seconds to synchronize the transmission signal.
Every time the power adaptor gets unplugged and with no batteries inserted, the main unit
will lose all the weather data.
Every time the outdoor sensor batteries are replaced, the sensor will synchronize with the
main unit again. You must press the "OUT" key for more than 3 seconds to synchronize
the reception signal.
Mounting the main unit
The main unit can be placed onto any flat surface or wall mounted at the desired location by
hanging hole, It is important to check that the radio signal (from the outdoor sensor and from
the DCF77 time signal) can be received well before mounting.
1) Mounting the outdoor sensor onto the stainless steel mast
For accurate results, the outdoor sensor mast should be securely mounted onto a horizontal
surface and in an open area away from trees and other coverings where rainfall or wind speed
may be reduced causing inaccurate reading.
The following diagram shows how the parts go together.
Publicité
