Sullair SR-125 Manuel D'utilisation page 21

Code: 02250129- - 688 SR- - 125 --- SR- - 200
Fig. 2 Safety and description labels on dryer (see Fig. 3)
S Model
S Serial No.
S Low/High side refrigeration
SR- - 125
S Max air pressure
S Max compressed air inlet
S Min. ambient
S Power supply
S Oil
S Min. circuit ampacity
S Max protective device rating
S Compressor
S Fan 1
S Fan 2
S Refrigerant
S Weight
h
QUALITY
a
CHECKED
INSPECTOR N. 302
circuit design pressure
Max ambient
Electrical diagram no.
QUALITY
CHECKED
b
INSPECTOR
N. 302
c
See Chapter 2
max.3µm
COD. 109574
d
Air inlet
e
Air outlet
Attention:
f
components under power
g
1 This unit is equipped with refrigerant as for quantity and kind clearly shown in operating manual and with
identification label.
2 Any ordinary test and / or refrigerant recharge by means of connections can take place only after refrigerant
evacuation. The evacuation must be proportional to dimensions and length of the connections used. The use
of the valve can be justified only when the dryer is not in working order.
3 During the unit guarantee period, the Schrader valve can be used by authorized staff only, otherwise any dam-
age caused by a wrong refrigerant recharge will not be under warranty.
Condensate drain connection
m
Never pass compressed air through
the dryer when it is stopped. Always
start the dryer 5 minutes before
slowly opening the air inlet valve.
If the airflow is to bestopped only
switch the dryer off after closing the
air inlet.
SETTING (hot gas valve)
Evaporating pressure in 0_C, with
precision manometer connected
at evaporator outlet.
WARNING:
Risk of electric shock
can cause injury or death.
Disconnect all remote electric
power supplies before servicing.
p
BSPP pipe threads
use supplied adapters
ATTENTION: SCHRADER VALVE
20
l
ATTENTION
n
o