Melnor 3050 Mode D'emploi page 8

3) TO SET STOP TIME OF 1ST CYCLE
Press or
Holding down key will scroll numbers for faster selection.
Press ACCEPT
ACCEPT
Unit will beep one (1) time and minutes will flash.
Press or
Holding down key will scroll numbers for faster selection.
Press ACCEPT t desired Stop Time MINUTES flash.
ACCEPT
Unit will beep one (1) time.
If in 12-hour mode, press ACCEPT t after selecting proper AM/PM setting using
Mist Cycle setting.
This AM/PM step is skipped for 24-hour mode and unit will go directly to Mist Cycle setting.
4) TO SET MIST CYCLE
Misting means that the timer will repeatedly open an close valve during the cycle for intermittent watering.
Press or
No = no misting: the timer waters continuously throughout entire cycle.
2 min = the timer will repeatedly water for 2 minutes, stop for 10 minutes, then restart.
5 min = the timer will repeatedly water for 5 minutes, stop for 10 minutes, then restart.
10 min = the timer will repeatedly water for 10 minutes, stop for 10 minutes, then restart.
15 min = the timer will repeatedly water for 15 minutes, stop for 10 minutes, then restart.
Press ACCEPT
ACCEPT
Water Days setting.
Note: Repeat steps 2-4 above for each additional cycle desired.
to select Stop Time HOUR. Unit will beep one (1) time for each key press.
when desired Stop Time HOUR flashes.
to select Stop Time MINUTES. Unit will beep one (1) time for each key press.
to select one of the following:
to choose desired flashing Mist Cycle. Unit will beep and flash two (2) times and go to
or . Unit will go directly to