Publicité
Les langues disponibles
Les langues disponibles
6. Drill pilot holes for #14 sheet metal screws. Before drilling the holes, make sure the hood will not hit the cowl panels when
mounted.
7. Fasten top of cowl to truck using the #14 x ¾" sheet metal screw supplied.
8. Slide the bottom flange of the cowl panel into the groove of the support block and mount the bracket assembly to the truck
body as shown below. Use the remaining ¼" hardware provided. (Leave loose for later adjustments)
9. Adjust cowl panels to desired positions and tighten hardware. Repeat for driver side starting from step 6.
10. Peel plastic coating from cowls. Polish with glass cleaner and soft cloth if necessary.
Page 2 of 6
SHOWING INSTALLATION AND
LOCATION OF BRACKET FOR DPF
IIPB036
08/2010
Publicité
