Change The Li-Ion Battery; Handling The Cutter Head - B.Braun Aesculap Bonum Mode D'emploi

Aesculap
Bonum large animal battery-operated clipping machine
Note
The Li-ion battery heats up slightly during charging.
Note
Disconnect the mains power cord at the mains socket
when the charger is not going to be used.
►
Only use the Aesculap charger GT643 (LC40) for charging the lithium
ion battery.
►
Insert the charger 22 power plug.
The LED of the operation indicator d and the LED of the warning indi-
cator e light up in succession for approx. 1 second, see Fig. F.
►
Place the Li-ion battery 21 in the charging bay of the charger 22 up
to the stop, see Fig. F.
The LED of the operation indicator d blinks and the Li-ion battery 21 is
charged.
When the LED of the operation indicator is permanently illuminated,
the Li-ion battery is completely charged.
4.4

Change the Li-ion battery

►
Hold the battery-operated clipping machine g with the cutter head
downwards so that the lithium ion battery 21 does not fall down when
loosened, see Fig. 1.
►
Loosen the battery lock f with your thumb.
21
Fig. 1
6
®
f
g
►
Remove the lithium ion battery 21, and push the charged and/or
uncharged replacement lithium ion battery GT641 (3INR19/66-1) into
the battery-operated clipping machine g, see Fig. 2.
Fig. 2
4.5

Handling the cutter head

Lubricating the shearing head
Damage to the clipping machine or
the cutter head due to incorrect
CAUTION
lubrication!
Only oil the cutter head when
►
the machine is running.
Never immerse the cutter head in
►
liquid of any kind!
►
Only use GT604 light lubricating oil.
►
Generously oil the cutter head at the lubrication point a before shear-
ing each animal, see Fig. A.
►
Oil spring leaves 7 2 to 3 times daily with 3 to 4 drops of oil, see Fig. C.
21
g