Power Fist 8064685 Manuel Du Propriétaire page 4

WARNING: Ensure you read, understand and apply safety instructions before use.
1. Connect the air tool to the air hose.
2. Press the trigger to operate the tool.
3. The flow of air may be regulated by adjusting flow valve at the base of the handle.
4. Ensure the air supply is clean and does not exceed 90 PSI while operating the tool. Too high an air pressure
and unclean air will shorten the product life due to excessive wear, and may be dangerous, cause damage or
personal injury.
5. Keep children away from the tool and work areas when using the tool.
DO NOT use any additional force upon the tool.
DO NOT allow tool to run freely for an extended period of time as this will shorten its life.
Maintenance
WARNING: Disconnect tool from air supply before changing accessories, servicing or
performing maintenance. Replace or repair damaged parts. Use genuine parts only.
Non-authorised parts may be dangerous.
1. Lubricate the air sander daily with a few drops of air tool oil dripped into the air inlet
2. Clean the tool after use. DO NOT use worn or damaged tool.
3. Loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size or type of hose
connectors. To remedy check the air supply .
b) Grit or gum deposits in the tool may also reduce performance. If your model has an air strainer (located
in the area of the air inlet), remove the strainer and clean it.
4. When not in use, disconnect from air supply, clean tool and store in a safe, dry location away from children.
Trouble Shooting
For any technical questions, please call 1-800-665-8685
4