CLAS OM 8035 Mode D'emploi page 11

OM 8035
ALUMINUM HUB BEARING REMOVAL SET
1
Now the half rings can be positioned behind the wheel hub as follows. (Fig.3) The slightly protruding edge on one
side of the half rings faces the wheel hub.
The inner diameter of the half rings has a slightly conical shape.
As soon as the half rings are attached, the support bolts can be inserted into the holes in the wheel hub until they
touch the half rings. (Fig.4)
Next, the pressure plate, small pressure piece, pressure bearing screw and pressure nut are placed as shown in (Fig 5).
3
5
Half
rings
Back nut
2
4
Screw with
nut with
bearing
Support
bolts
A