Chapter 3 Using The Disk Unit; Inserting A Disk Cartridge - Sony RMO-S561 Mode D'emploi

Chapter 3 Using the Disk Unit

Inserting a Disk Cartridge

Use the following Sony 5.25-inch MO disks in
your RMO-S561 disk unit.
• EDM-9100B (4,096 bytes/sector, 9.1 Gbytes)
• EDM-8600B (2,048 bytes/sector, 8.6 Gbytes)
• EM1-9100B (1,024 bytes/sector, 9.1 Gbytes)
• EM5-9100B (512 bytes/sector, 9.1 Gbytes)
• EDM-5200B (2,048 bytes/sector, 5.2 Gbytes)
• EDM-4800B (1,024 bytes/sector, 4.8 Gbytes)
• EDM-4100B (512 bytes/sector, 4.1 Gbytes)
• EDM-2600B (1,024 bytes/sector, 2.6 Gbytes)
• EDM-2300B (512 bytes/sector, 2.3 Gbytes)
• CWO-9100B (4,096 bytes/sector, 9.1 Gbytes )
• CWO-8600B (2,048 bytes/sector, 8.6 Gbytes)
• CWO-5200B (2,048 bytes/sector, 5.2 Gbytes )
• CWO-4800B (1,024 bytes/sector, 4.8 Gbytes)
• CWO-4100B (512 bytes/sector, 4.1 Gbytes)
• CWO-2600B (1,024 bytes/sector, 2.6 Gbytes )
• CWO-2300B (512 bytes/sector, 2.3 Gbytes)
1
Press the POWER switch located on the left
side of the front panel.
This turns on the disk unit and causes the
POWER indicator to light up.
Press the POWER switch
2
Start up the host computer. Refer to the
manual supplied with the host computer for
the start up procedure.
3
Insert a disk cartridge with the side you want
to use facing upwards.
To use Side A, insert the
disk with "A" facing
upward.
4
Access or write data on the disk using
software commands on the host computer.
The BUSY indicator lights up while the unit
is accessing the disk.
■ What to do if the disk unit stops
operating
When the temperature in the disk unit exceeds
the preset level, the BUSY indicator starts
flashing on and off at about 2-seconds intervals,
regardless of whether or not a disk is being
accessed, and the disk unit stops operating.
If this happens, you should improve the
ventilation of a setting area.
If the disk unit still refuses to operate, unplug the
unit and contact your dealer.
Chapter 3 Using the Disk Unit
13