First Time Setup
First time setup screen is displayed only when the TV is turned on for the first time after the power cord is
inserted into a wall outlet and when "Auto power on" (p. 29) is set to "No".
12
tc̲L32̲37̲x2̲eng̲0567-2.indb 12
tc̲L32̲37̲x2̲eng̲0567-2.indb 12
Turn the TV On with the POWER button
(TV)
(Remote)
or
or
Configure your viewing mode
Select your language
Language / Idioma / Langue
English
Español
Français
Select your viewing mode
Set viewing mode
Home Use
Store Demonstration
OK
Please select your viewing environment.
Select
Select "Home Use" when using this TV in your
RETURN
home.
Please confirm your selection (Home Use) before pressing OK button.
If you select "Store Demonstration" by mistake in
confirmation screen will be displayed.
You are selecting the store demonstration mode.
Yes
No
If you select "Yes", the picture mode will regularly reset
to "Vivid" and a Picture Refresh message will be displayed on the
screen.
Select "No" and return to previous screen
If you select "Yes", Screen enters the store demonstration mode.
To display the "Set viewing mode" screen again as shown above and select
"Home Use", do one of the following:
• Press and hold down the side POWER button for at least five seconds.
• Unplug power cord for 30 seconds and plug it again.
Note
is not available on
is not available on
When you have used
"Language" settings will be displayed.
If you use any other step other than
button to quit before completing the settings, the next time you turn the TV on "First
time setup" will not be automatically displayed.
• The settings up to that point are saved.
• You can reset the settings using "First time setup". (p. 29)
To change the setting (Language, ANT/Cable setup, Input labels, Clock) later, go to
the Menu screen (p. 29)
select
OK
(Be sure to select "Home use")
Step 2 of 6
select
OK
select
OK
.
.
-
.
to turn the TV off, the next time you turn the TV on the
to turn the TV off, or if you used the EXIT
,
2010/04/23 17:42:29
2010/04/23 17:42:29