After Installation - Beacon Lighting FANAWAY EVO1 LED Manuel D'installation

Fanaway EVO1 LED Installation Instructions
WOBBLE:
NOTE: ceiling fans tend to move during operation due to the fact that they are mounted on a rubber
grommet. If the fan was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a
few centimetres is quite acceptable and DOES NOT suggest any problem.
TO REDUCE THE FAN WOBBLE: Please check that all screws which fix the mounting bracket and down
rod are secure.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and
frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in
fan motor noise. This is normal. Please allow a 24-hour "breaking -in" period, most noises associated
with a new fan disappear during this time. All electric motors are audible to some extent. Please note that
this is not a product fault, and as such is not covered under warranty.
CARE AND CLEANING
1) Periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free
cloth to avoid scratching the paint finish. Please turn OFF electricity power when you do so.
2) Ensure that the product does not come in contact with corrosive chemicals/solvents or abrasive
cleaners etc.
3) To clean, wipe with a soft damp clean cloth. Do NOT soak or immerse the product in water or other
liquids.It could damage the motor or the blades and create the possibility of an electrical shock.
4) The motor has a permanently lubricated ball bearing so there is no need to oil.
NOTE: Always turn OFF the power before attempting to clean your fan.
10 | P a g e

AFTER INSTALLATION

V 1 . 2 ( 1 / 2 0 2 1 )