Hanging The Fan - Beacon Lighting FANAWAY EVO1 LED Manuel D'installation

Fanaway EVO1 LED Installation Instructions
Remove the ball joint (4) from down rod (6) by loosening the set screw (3), insert the motor wires (1) and LED
1)
light cable (2) through the down rod (6).
Insert the down rod to the coupling (8), line up the coupling holes with the down rod holes and insert the bolt
2)
(9). Then insert the pin (10) to the end of the bolt.
Secure the down rod and coupling by tightening the two set screws (11) on the coupling.
3)
Feed the bolt and pin cover (7) and the canopy (5) through the down rod.
4)
Secure the ball joint back to the down rod. Fig. 6
5)
NOTE: When installing the fan with extension down rod, please use the LED light extension cable (19 -
Fig. 1).
Pass the power supply wires (C) from the ceiling outlet box (B) through the center of the ceiling mounting
bracket (D). Install the ceiling mounting bracket (D) on the outlet box (B) with the mounting screws (F)
provided with the outlet box and washers (E) provided with fan. Fig. 7
Fig. 7
Lift the fan assembly onto the mounting bracket. Ensure the registration slot (A) of the hanger ball is
positioned on the stopper (B) of the mounting bracket (C) to prevent the fan from rotating when in
operation. Fig.8
5 | P a g e
INSTALLING THE DOWN ROD

HANGING THE FAN

Fig. 6
Fig. 8
V 1 . 2 ( 1 / 2 0 2 1 )