Fan Installation; Electrical Wiring Diagram - Beacon Lighting FANAWAY EVO1 LED Manuel D'installation

Fanaway EVO1 LED Installation Instructions
Light kit installation
CAUTION – To reduce the risk of electric shock, disconnect the electrical supply circuit to the fan before
installing light kit. Light kit weight: 6 .16 lb.
1. Remove the lamp shade (5) from the lamp base (4) by turning it anti-clockwise.
2. Loosen the screw (1) from the base bracket (3). Align the two slot screws (2) with the keyhole slots of
the lamp base (4).
3. Turn the lamp base counter clockwise until the slot screws are firmly at the end of the slots.
4. Secure screw (1) back to the base bracket. Tighten all three screws. Do not over-tighten.
5. Connect the upper plug (6) from the fan to the lower socket (6) in the LED board (7).
6. Finally install the lamp shade to the lamp base by turning it clockwise.Fig.9
WARNING: To avoid possible electrical shock, be sure you have turned off the power at the main circuit
panel.
Follow the steps below to connect the fan to your household wiring. Use the wire connecting nuts supplied
with your fan. Secure the connectors with electrical tape. Make sure there are no loose wire strands or
connections.
1. Connect the household live supply wire (black) to receiver input wire (black, AC IN L) as shown in
Fig. 10a.
2. Connect the household neutral supply wire (white) to the receiver input wire (white, AC IN N).
3. Connect the household ground wire to the fan bracket ground wire (green) and fan body ground wire.
6 | P a g e

FAN INSTALLATION

Fig. 9

ELECTRICAL WIRING DIAGRAM

V 1 . 2 ( 1 / 2 0 2 1 )