Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Airfusion Radar Installation Instructions
INSTALL THE CANOPY COVER
•
Loosen 2 screws (2) from the mounting bracket. Fig.8
•
Loosen 2 screws (1) by half thread from the mounting bracket. Fig. 8
•
Lift the hanging plate of the fan assembly up to the mounting bracket and let the L-shape slot on the
hanging plate go through the screws (1) on the mounting bracket. Turn the hanging plate until it locks
in place at the end section of the L-shape slot and secure it by tightening the two screws (2). Avoid
damaging the electrical wiring prepared previously.
•
Finally attach the motor housing to the hanging plate and secure it by pushing the hooks (3) into the
slot holes and turn it anti clockwise.
BLADE INSTALLATION
•
Insert the blade screws through the blade assembly in the following order - bracket kit (2) and blade (1).
Attach the blade assembly to the motor and secure it by tightening the 2 screws (3). Fig. 9
•
Repeat to install the other blades.
•
Finally install the bottom cover (4) to the shaft of the motor by rotating it clockwise.
5 | P a g e
FINISHING THE INSTALLATION
Fig. 8
Fig. 10
Fig. 9
C T
Publicité
Table des Matières
