Beacon Lighting FANAWAY EVO1 LED Manuel D'installation page 7

Fanaway EVO1 LED Installation Instructions
Metal safety cable
Black (To Motor L)
)
White (To Motor N
)
White (To Motor N
Black (To Motor L)
of the mounting bracket, and then insert the remote receiver into the top layer of the mounting bracket.
Safety calbe assembled
7 | P a g e
Black L (Live)
White N (Neutral)
Black (AC IN L)
(Live)
White (AC IN N)
(Live)
PWM Signal wires
2
1
Driver Power supply wires
3
LED light cable
Fig. 10a
4. Connect the receiver output wire (black,
TO MOTOR L) to motor live input wire (black,
TO MOTOR L).
5. Connect the receiver output wire (white,
TO MOTOR N) to motor neutral input wire
(white, TO MOTOR N)
6. Connect the LED driver power input
wires and remote receiver power output
wires via the 2-port quick connectors (3);
7. connect the LED driver PWM signal
input wires and remote receiver PWM signal
output wires via the 3-port quick connectors
(2)
8. also connect the LED driver output
wires and LED light wires via the quick
connectors (1)
9. pull the metal safety cable on the
security hook, tight the safety cable (Fig.10a
& Fig10b)
10. After connecting the wires, spread them
apart so that the green and white wires are
on one side of the outlet box and the black
and blue wires are on the other side.
11. Turn the connecting nuts upward and
push the wiring into the outlet box.
12. Insert the LED driver into the lower layer
Fig. 10b
V 1 . 2 ( 1 / 2 0 2 1 )