inventiv 202066 Notice page 26

OPERATING INSTRUCTIONS
202066 CORDLESS DRILL 12V
Note: Before using the tool, read the instruction
book carefully.
Intended Use
The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
BEFORE PUTTING INTO OPERATION
1. RECHARGING BATTERIES
a) CHARGING THE BATTERY
The battery charger supplied is matched to the Li-ion
battery installed in the machine. Do not use another
battery charger.
The Li-ion battery is protected against deep discharging.
When the battery is empty, the machine is switched off
by means of a protective circuit: The tool holder no longer
rotates.
In a warm environment or after heavy use, the battery
pack may become too hot. Allow time for the battery to
cool down before recharging.
WARNING!
Do not continue to press the On/Off switch after the tool
has been automatically switched off. The battery can be
damaged.
b) IMPORTANT NOTES FOR CHARGING THE
BATTERY (See Fig. A)
The battery in your new tool is not charged when it leaves
the plant. Therefore it must be full charged before using
the first time
NOTE: If the battery pack is very hot you must remove
your battery pack from the charger and allow your
battery pack to cool first to ambient temperature and then
recharging can be started.
To prevent damage to the Battery Pack, when charge
runs out, please charge the battery to reach full or no less
than half charge before storage.
If the tool will not be used for long periods of time, charge
the battery every 3-6 months
WARNING:
When battery charge runs out after continuously
use or exposure to direct sunlight or heat, allow
time for the tool to cool down before re-charging to
achieve the full charge.
26
SAFETY AND OPERATING MANUAL