inventiv 202066 Notice page 27

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1) Plug the charger into an appropriate outlet, the green
LED (b) will light.
2) Push the battery pack(7) into the charger, the red LED
(a) will light to indicate that charging has started.
3) When charging has completed, the green LED (b)
will light. Unplug the charger and remove the battery
pack.
Light
RED on
Green on
2. REMOVE OR INSERT BATTERY PACK (See Fig. B)
Press the battery pack release button and remove the
battery pack from the tool. After recharge slide the battery
pack into tool's battery port. A simple push and slight
pressure will be sufficient.
OPERATION
1. ON / OFF SWITCH (See Fig. C )
Depress the On/Off switch to start and release it to stop
your drill. The on/off switch is fitted with a brake function
which stops your chuck immediately when you quickly
release the switch.
It is also a variable speed switch that delivers higher
speed and torque with increased trigger pressure. Speed
is controlled by the amount of switch trigger depression.
WARNING:
Do not operate for long periods at low speed
because excess heat will be produced internally.
2. SWITCH LOCK
The switch trigger can be locked in the OFF position. This
helps to reduce the possibility of accidental starting when
not in use. To lock the switch trigger, place the rotation
control in the center position.
3. REVERSIBLE (See Fig. C)
For drilling and screw driving use forward rotation marked "
" (lever is moved to the left). Only use reverse rotation
marked "
" (lever is moved to the right) to remove
screws or release a jammed drill bit.
202066 CORDLESS DRILL 12V
Status
Charging
Fully charged
27
SAFETY AND OPERATING MANUAL

Publicité

Table des Matières
loading

Table des Matières