inventiv 202066 Notice page 30

TROUBLE SHOOTING
1. WHY DOES THE DRILL NOT TURN ON WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of the trigger, is positioned in the lock
function. Unlock the forward/reverse rotation control by putting it into the required rotation
position. Push the trigger and the drill will start to rotate.
2. THE DRILL STOPS BEFORE THE SCREW IS COMPLETELY TIGHTENED. WHY?
Verify the torque position of the torque adjusting ring, you can find the torque-adjusting ring
between the chuck and the drill body. Position 1 is the lowest torque (screw driving force) and
position 18 is the highest torque (screw driving force). Position
the torque adjusting ring to a higher position to reach the best result.
3. REASONS FOR DIFFERENT BATTERY PACK WORKING TIMES
Charging time problems, as above, and having not used a battery pack for a prolonged time will
reduce the battery pack working time. This can be corrected after several charge and discharge
operations by charging & working with your drill. Heavy working conditions such as large screws
into hard wood will use up the battery pack energy faster than lighter working conditions. Do not
re-charge your battery pack below 0
MAINTENANCE
Remove the battery pack from the tool before carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry cloth. Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep all working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This is normal and will not damage your power tool.
TROUBLESHOOTING
1 If your drill will not operate, check the power at the mains plug.
2 If the drill is not cutting properly, check the drill bit for sharpness, replace drill bit if worn.
Check that the drill is set to forward rotation for normal use.
3 If a fault can not be rectified return the drill to an authorized dealer for repair.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with household waste. Please recycle
where facilities exist. Check with your local authorities or retailer for recycling advice.
Li-Io
202066 CORDLESS DRILL 12V
o
C and above 45
30
SAFETY AND OPERATING MANUAL
is for drill operation. Regulate
o
C as this will affect performance.