inventiv 202066 Notice page 28

202066 CORDLESS DRILL 12V
WARNING: Never change the direction of rotation
when the chuck is rotating, wait until it has
stopped!
4. TWO-SPEED GEAR CONTROL (See Fig. D)
The drill has a two-speed gear control designed for drilling
or driving at LOW (mark is 1) or HIGH (mark is 2) speeds.
A slide switch is located on top of the drill to select either
LOW or HIGH speed. When using the drill in the LO speed
range, the speed will decrease and the drill will have
greater power and torque. When using the drill in the HI
speed range, the speed will increase and the drill will have
less power and torque.
Gear I
Low speed range: for screwdriving or working with large
drilling diameter
Gear II
High speed range: for working with small drilling diameter
WARNING:
To prevent gear damage, always allow the chuck
to come to a complete stop before changing the
direction of rotation or the two-speed gear control.
5. CHUCK ADJUSTMENT (See Fig. E)
To open the chuck jaws rotate the front section of the
chuck. Insert the drill bit between the chuck jaws and
rotate the front section in the opposite direction. Ensure
the drill bit is in the center of the chuck jaws. Finally, firmly
rotate the front chuck section in the opposite directions.
Your drill bit is now clamped in the chuck.
6. TORQUE ADJUSTMENT (See Fig. F)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque adjustment
ring. The torque is greater when the torque adjustment
ring is set on a higher setting. The torque is less when the
torque adjustment ring is set on a lower setting.
Make the setting as follows:
1 - 4
5 - 9
10 - 18
28
SAFETY AND OPERATING MANUAL
for driving small screws
for driving screws into soft material
for driving screws into soft and hard material
for heavy drilling